P0298
Powertrain Codes
P0298 - MAZDA - Engine Oil Protection Strategy Enabled
Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of Power
- Engine Surge
Possible Causes
- Very high engine RPM for an extended period of time.
- Overheating condition.
- Malfunction Engine Oil Temperature (EOT) sensor or circuit (vehicles w/EOT sensor).
- Low or dirty motor oil condition.
- Oil pressure switch faulty.
When Detected
P0298 is set when the vehicle has been running below 1,000 rpm and less than 20 mg/stroke MFDES with EOT sensor signal reading above 110 C (230 F). The time to set the fault is dependent on EOT and Intake Air Temperature (IAT) temperatures, and can vary between approx. 15 to 45 minutes
Tech Notes
On engines which are equipped with an oil temperature sensor, the Engine Control Module (ECM) reads oil temperature to determine if it is excessive. When an oil temperature sensor is not present, the ECM uses an oil algorithm to infer actual temperature. Engine shutdown strategy function is the same on vehicles with and without oil temperature sensors.
Description
Indicates the Engine Oil Temperature Protection (EOT) strategy in the Engine Control Module (ECM) has been activated. This temporarily prohibits high engine speed operation by disabling injectors, reducing the risk of engine damage from high engine oil temperature.